Description
Dprex UF S 010 Natural resin is unfilled ABS compounds. This injection-molding general purpose grade offers high flow, medium impact strength. This product is available in Black & other colors on request.
Application
This grade is most suitable for applications for housing of shaver, vacuum cleaners, camera, etc
Material Handling & Processing
The Material packed in moisture-proof Bags. Special care should to take for avoid moisture absorption and cross contamination with other material during processing. While adding regrind material, colour variation, mechanical properties may be affected and close monitoring recommended.
Recommended Pre Drying conditions:
Dehumidified air-dryer / Hot air Oven Temp: 80 oC – 90 OC Time: 2-3 Hours
|
Barrel |
Mold |
|||
|
Feed Zone |
Compression Zone I |
Compression Zone II |
Nozzle |
|
|
200 – 230 °C |
230 – 250 °C |
235 – 250 °C |
240 – 250 °C |
80 – 110 °C |
After the Molding process cycle is over or after a power failure, we strictly recommend that the barrels must be flushed / purged / cleaned with suitable material (HIPS or PP) especially while processing Glass filled and FR Grades; before restarting the machine.
Product Safety
For safety instructions please refer to Material Safety Data Sheet*
PRODUCT DATA SHEET DPREX UF S 010 NATURAL
|
PROPERTIES |
STANDARD |
UNIT |
VALUES |
|
|
|||
|
Physical |
|||
|
Melt Flow Rate @ 220 °C/ 10 Kg Load |
ASTM D 1238 |
gm/10min |
>25 |
|
Mechanical |
|||
|
Tensile Strength @ 50 mm/min |
ASTM D 638 |
Kg/cm2 |
480 |
|
Izod Notched Impact Strength @ 23 Deg. C |
ASTM D 256 |
Kg.cm/cm |
>14 |
|
Thermal |
|||
|
Vicat Softening Temperature @ 120 °C/h,50N |
ASTM D 1525 |
Deg.C |
95 |
|
Optical |
|||
|
Specular Gloss, 60° |
ASTM D 523 |
% |
>95 |
General Disclaimer
The information given above should not be construed as Warranty for performance, purpose or suitability of the material for customer’s application. Each customer must determine the suitability of the material through appropriate testing and analysis. Values shown above are tests conducted on laboratory test specimens and represent data that fall within the Standard range of properties. These values are for specification purposes only. These values alone do not represent sufficient basis for suitability of any part design and is not intended for use in establishing maximum, minimum, or range of values.